Eberspracher Airtronic D2 Operations Instructions download pdf (Page 26)

Removing the cover from the AIRTRONIC

(see picture 1)

Unlock both seal plates, lift cover and take up to the front.

Note:

The cover must always be removed from the

AIRTRONIC

for all repair stages.

You may have to wait for the device to cool down.

Cable harness exit out of the harness either left or right.

Fig. 1

햲 Cover

햳 Seal plates

Removing the controller (see fig. 2)

• Remove the

AIRTRONIC

cover (see fig. 1).

Unscrew fastening screw, press retaining brackets

together, lift out the controller. Unclip the lines from the

holder of the controller (observe the positions of the lines).

Withdraw the bushing (lower part) from the outer case.

Disconnect the controller from the controller. The

controller can now be removed.

Note:

When reassembling the controller, ensure that the lines

are correctly clipped in the holder of the controller, and

that the connectors are plugged into the controller (non-

interchangeable).

Tightening torque for the fastening screw no. 햲: 2

+0.2

햲햳햴

햵

Fig. 2

햲 Fastening screw

햳 Retaining brackets

햴 Controller

햴 Bushing

햲

햳

Checking the controller

A test instrument is necessary to check the controller in

dismantled state. The test instrument is connected up to

the PC and tests the controller with an installed test

programme.

Order no. – test instrument ------

The test instrument is currently

in preparation

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Eberspracher Airtronic D2 Operations Instructions Page 26

Comments to this Manuals