Eberspracher Airtronic D5 Service Manual download pdf (Page 12)

Installation3

Installation and mounting position

The heater is suitable and approved for installation in

vehicle interiors used by people.

Installation in the driver’s cab or passenger

compartments of coaches or buses with more than

9 seats is not allowed.

When installing in compartments used by persons, the

exhaust, combustion air and fuel pipes in these areas

must not have any detachable connections and must

be laid splash-proof in the penetrations.

For this reason, the heater can be fitted onto the

vehicle floor or an outer panel of the vehicle using the

flange seal in the heater’s base.

The electronic control is integrated in the heater, which

makes wiring during installation much easier.

• When installing the heater, always make sure there is

sufficient clearance left for intake of the heater air and

for dismantling the glow plug and controller.

• Observe the regulations and safety instructions for

this chapter, given on pages 4 – 7.

Please note!

Installing the 24 V heater in a vehicle for

the transport of dangerous goods

according to ADR

The heater can be installed in vehicles used for the

transport of dangerous goods according to

ADR.

If installed with the appropriate electrical wiring, the

heater fulfills the ADR regulations, see circuit

diagrams at the end of this manual.

Detailed information about the ADR regulations is

given in the leaflet no. 25 2161 95 15 80.

For installation of the heater in vehicles for the

transport of dangerous goods, the regulations of

ADR must also be observed.

Please note!

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

No comments

Eberspracher Airtronic D5 Service Manual Page 12