Eberspracher Airtronic D5 Service Manual download pdf (Page 15)

Installation3

Installation and fixing

Make the through-holes for exhaust, combustion air

and fuel as shown in the drilling hole pattern.

The support surface for the heater base must be flat.

The Ø 10.5 mm hole for the “dosing pump“ cables is

not included in the drilling hole pattern and must be

drilled depending on the installation.

If the sheet metal of the support surface is thinner than

1.5 mm, an additional reinforcing plate will have to be

fitted.

Order no: reinforcing plate 25 1729 89 00 03

Drilling hole pattern

Fixing the heater to the vehicle floor Fixing the heater horizontally to the vehicle wall

(panel)

1 There must be sufficient clearance between the

heater and the vehicle floor – in addition, check

that the fan wheel runs freely.

2 The mounting surface must be flat and smooth.

3 The flange seal must be fitted.

4 The vehicle wall must be flat and smooth.

5 Spring washer

6 4 x M8 hexagonal nut (tightening torque 11

Nm)

7 Reinforcing plate (if needed, Order no.

25 1729 89 00 03)

1 Contour of the bearing surface.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

No comments

Eberspracher Airtronic D5 Service Manual Page 15