Eberspracher Airtronic D5 Service Manual download pdf (Page 111)

PRODUCT INFORMATION | 111

Airtronic

Airtronic M

Airtronic L

Air heater 8 L / V 7 S

Hydronic / Hydronic 2 / Hydronic 2 C

Hydronic M

Hydronic L

Order No.

suitable for unlimited use ~ suitable for limited use

10 | EXHAUST SYSTEM / COMBUSTION SYSTEM PARTS

GENERAL INFORMATION:

The combustion air system is to be fitted so that

the connection at the heater fitting is tight.

the pipe mouth never faces into the head wind.

as far as possible, no water can splash into the pipe mouth, or otherwise

runs out again immediately without penetrating into the heater.

no exhaust fumes from the heater or vehicle engine can be sucked into the

system.

Please also comply with the safety instructions for this chapter in the heater

documentation.

Installing the exhaust system:

Exhaust pipes should always slope down to the pipe mouth.

If this is not possible, a hole must be provided for water to drain at the

lowest point.

If this point is not on the outside (e.g. boat machine room), this opening

must be connected directly with a so-called overflow vessel.

Constrictions in the cross-section of the exhaust pipe compared to the

exhaust connection at the heater must be avoided at all costs.

Please refer to the Technical Description and installation instructions for

permitted lengths, diameters and bends in the combustion air and exhaust

pipes.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 147 148

No comments

Eberspracher Airtronic D5 Service Manual Page 111