18
Installation3
Exhaust system
(For exhaust system diagram see page 19)
Installing the exhaust system
The universal installation kit includes a flexible exhaust
pipe, inner Ø 24 mm, 1300 mm long. The flexible
exhaust pipe can be shortened to 20 cm or lengthened
to max. 2 m, depending on the installation conditions.
In addition, an exhaust silencer can be inserted in the
exhaust pipe system. In this case, fix the exhaust
silencer to the vehicle in a suitable position. Lay the
flexible exhaust pipe from the heater to the exhaust
silencer and fasten with a pipe clip.
Connect an exhaust end pipe with an end sleeve to the
exhaust silencer and fix with a pipe clip.
Caution!
Safety instructions!
The whole exhaust system gets very hot while the
heater is running and immediately afterwards.
This is why the exhaust system must be laid according
to these installation instructions
• The exhaust outlet must end in the open air.
• The exhaust pipe must not protrude beyond the
lateral limits of the vehicle.
• Install the exhaust pipe sloping slightly downwards. If
necessary, make a drain hole with an approx. Ø of
5 mm at the lowest point as a condensation outlet.
• Important functional parts of the vehicle must not be
impaired (keep sufficient clearance).
• Install the exhaust pipe with sufficient clearance from
heat-sensitive components. Pay particular attention
to fuel pipes (made of plastic or metal), electrical
cables and brake hoses, etc.!
• Exhaust pipes must be safely fixed (recommended
clearance of 50 cm) to avoid damage from vibrations.
• Lay the exhaust system so that the outflowing
exhaust gases are not sucked in as combustion air.
• The mouth of the exhaust pipe must not become
clogged with dirt and snow.
• The mouth of the exhaust pipe must not point in the
direction of travel.
• Always fix the exhaust silencer to the vehicle.
Danger!
Risk of injuries and burns!
Every type of combustion produces high temperatures
and toxic exhaust fumes. This is why the exhaust
system must always be laid according to these
installation instructions.
• Do not perform any work on the exhaust system
while the heater is working.
• Before working on the exhaust system, switch off the
heater first and wait until all the parts have
completely cooled down, wear safety gloves if
necessary.
• Do not inhale exhaust fumes.
• Comply with the regulations and safety instructions
for this chapter given on page 4 – 7.
• The exhaust end pipe should be much shorter than
the flexible exhaust pipe from the heater to the
exhaust silencer.
Please note!
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals